MACHINING CASE / 06
Custom Precision Parts.
A selection of custom brackets, locating plates, clamping jaws, sleeves and shafts for varied equipment applications and small-batch production.
- MATERIAL
- Aluminium, copper alloys, stainless steels
- FINISH / PROCESS
- Finish specified per application
- BATCH
- Small-batch production

01
Machining challenges
Irregular part geometry may not offer stable clamping surfaces. Interrelated holes, slots and angled faces demand consistent datums, and each material type calls for its own machining approach — the work is in the review, not the cycle time.MANUFACTURING ROUTE
STEP 01
Drawing review and DFM
STEP 02
Modelling and simulation
STEP 03
Blank preparation and temporary datums
STEP 04
Roughing and stress relief
STEP 05
5-axis finishing
STEP 06
Support removal
STEP 07
Finishing and inspection
KEY CONTROL POINTS
—
What the route watches
- Temporary locating features, custom soft jaws, flexible supports
- Material-specific tooling and cutting parameters
- Critical tolerances between ±0.01 to ±0.02 mm on specified features
DIMENSIONAL & SURFACE INSPECTION
—
How it gets verified
- Free-state CMM inspection of critical dimensions and feature positions
- First-article reports on new parts
- Material documentation on request
- Surface-finish checks per the agreed scope
The requirements and manufacturing route shown here apply to this project. New components are reviewed against their own drawings and agreed specifications — published values are project-specific requirements, not general capability limits.