NEXUS Send drawings
ENGINEERING SUPPORT

A drawing review, in plain terms.

Design for manufacturability sounds abstract. Ours is four concrete questions asked against your drawing before a single blank is cut — and changes only happen after you agree to them.

QUESTION 01

Geometry & access

Can every feature be reached with a tool, and can the part be held while it is? Workholding, datum surfaces, thin-wall deflection and the sequence of operations get resolved here — before they become surprise costs.
QUESTION 02

Material & route

Grade, temper and starting stock (billet, plate or casting) set the route. Heat treatment, coating and grinding each reorder the sequence, and the route is planned around them, not patched after.
QUESTION 03

Tolerances & finish

Which features are actually critical, what the datums are, and whether each value applies before or after coating or heat treatment. Tight values only on the features that need them keeps cost proportionate.
QUESTION 04

Inspection & records

Which dimensions get verified, on what equipment, in what condition — free-state or restrained — and what report travels with the lot. First-article and final inspection formats are agreed up front.

How the conversation runs

Share — send the drawing or model with quantity and project notes. Incomplete information is fine; we say what's missing instead of guessing.

Review — the four questions get asked. Where a specification is unclear, it becomes a question, not an assumption.

Confirm — proposed changes are discussed and agreed before implementation. Your drawing stays the controlling document; our job is to make it manufacturable, not to redesign it.

COMMON QUESTIONS

Asked before drawings move.

Can I start without a finished design?
Yes. Send what exists — even a sketch and the functional requirements. The review identifies what's missing and what has to be fixed before quoting.
Will you change my design?
Only after discussion and your explicit agreement. Practical improvements are proposals; the approved drawing governs production.
What should I send?
The current drawing or 3D model, material grade if known, quantity, delivery target, and any critical tolerance, surface or inspection requirements. See the RFQ checklist.
Is every review the same?
No — scope follows part complexity and the documentation you provide. A stepped shaft and a 5-axis housing trigger very different questions.
START WITH YOUR DRAWING

Start the review with a drawing.

Send the part and the requirements that matter — the review is free and the quotation follows it.

Chat on WhatsApp