NEXUS Send drawings
MANUFACTURING GUIDE / 07

CNC machining tolerances: ISO 2768, drawings and CMM.

Tolerance questions decide both the manufacturing route and the quotation. This guide explains how general tolerance standards, drawing-specified values and CMM verification fit together.

Where a tolerance requirement actually comes from

The drawing is the controlling document. ISO 2768 covers un-toleranced dimensions only — it does not apply to individually toleranced features. Mating, sealing and parallelism requirements belong on the drawing explicitly, with datums. A "ISO 2768-mK" note is a starting point, not a complete precision specification.

How tolerances are read during review

Review order: datum system → individually toleranced features → general-tolerance note. The checks: are datums connected, is the inspection condition stated, do coating or heat treatment change what a value means. Ambiguities become questions before quoting, not findings after inspection.

What the inspection equipment covers

A dedicated Mitutoyo LEGEX 774 CMM with a 700 × 700 × 450 mm measuring range. Measuring range is not maximum part size — geometry and fixturing bound that. Inspection scope, frequency and report format are part of the quotation.

What project records show (project-specific values)

  • Thin-wall enclosure cover: flatness ≤ 0.05 mm — 6061-T651, 426 × 221 × 36 mm
  • Rotary engine housing: bore coating 0.15 ± 0.01 mm, Ra ≤ 0.12 µm after HVOF and profile grinding
  • Brass RF housing: CMM inspection of channels, mating faces and locating features

How tolerance decisions affect the quotation

Tight tolerances add steps: post-coating or post-heat-treatment inspection, fixturing and stress relief on thin sections, and real CMM report time. Mark only the truly critical features — cost should follow risk.

What to specify in your RFQ

DecisionWhy it matters
Tolerance critical features individuallyGeneral standards cover un-toleranced dimensions only
State datums and inspection conditionFlatness and parallelism need datums and a stated condition
Confirm verification stage post-coating / HTValues may apply to the finished surface, not the machined one
Name the report formatCMM, roughness and coating reports are agreed per project

Representative critical tolerances in published cases: ±0.01 to ±0.02 mm — assessed per drawing, not assumed.

START WITH YOUR DRAWING

Turn the guide into a quotation.

Chat on WhatsApp