NEXUS Send drawings
MANUFACTURING GUIDE / 06

5-axis machining for complex housings.

Five-axis capability is useful only when it is connected to the drawing, workholding and verification plan. The published case: ZL207 rotary engine housing, Ø300 × 110 mm, HVOF bore coating and profile grinding.

Select the route around the features

A five-axis RFQ is a starting point, not a complete process definition. Tool access, locating surfaces, fixture stability and feature relationships still get reviewed — and machine travel alone doesn't determine fit; tool, fixture and orientation clearance matter too.

Make datum relationships explicit

The published case ran on common datums and dedicated fixtures, with bore-to-end-face perpendicularity as a focus. Identify the datum system and the critical relationships — internal profiles, holes, fins, mating faces. If locating surfaces are limited, provide casting or stock information so temporary location gets reviewed, not improvised.

Separate drawing requirements from measured results

The case specified coating thickness 0.15 ± 0.01 mm and bore roughness Ra ≤ 0.12 µm. Those are requirements for that component — not achieved results and not general factory limits. Quote tolerance only after reviewing material, geometry, process and inspection method.

Use the equipment configuration as a screening input

Seven simultaneous five-axis machines: three DMC1375 (1300 × 750 × 750 mm travel, 400 mm max rotary Ø) and four V-400U (400 × 400 × 400 mm travel). Equipment figures describe the machine; suitability depends on geometry, orientation and workholding.

Agree verification and responsibility

CMM checks on bore profile and end faces; coating-related checks; wear testing validated by the customer. New inquiries should separate supplier inspection, specialist process checks and customer validation up front — see the tolerances guide.

START WITH YOUR DRAWING

Turn the guide into a quotation.

Chat on WhatsApp