NEXUS Send drawings
MACHINING CASE / 02

Precision Stepped Shaft.

A custom camshaft with stepped journals, an eccentric cam section and threaded ends — where heat-treatment distortion and journal finish decide the route.

MATERIAL
20CrMnTi alloy steel
FINISH / PROCESS
Carbonitrided and ground
REPRESENTATIVE SIZE
Approx. Ø35 × 260 mm
APPLICATION
Engine valve timing
Precision Stepped Shaft — machined part
Representative component — NEXUS capability profile REV 23, p.6
01

Machining challenges

The eccentric cam geometry must align to the journal datums after heat treatment, not just after turning. Carbonitriding distortion, journal finish and dynamic balance are the three concerns the route is built around.
MANUFACTURING ROUTE
STEP 01

Blank preparation and pre-heat treatment

STEP 02

Rough and semi-finish turning

STEP 03

Carbonitriding

STEP 04

Center-hole correction

STEP 05

Finish grinding

STEP 06

Polishing and balancing

KEY CONTROL POINTS
—

What the route watches

  • Cam phase and journal alignment
  • Heat-treatment distortion
  • Surface hardness and finish
  • Critical journals and cam profile: Ra ≤ 0.4 µm
DIMENSIONAL & SURFACE INSPECTION
—

How it gets verified

  • Cam profile and phase verification
  • Journal dimensions and roundness
  • Surface finish
  • Case depth and hardness
  • Magnetic particle testing
  • Dynamic balance

The requirements and manufacturing route shown here apply to this project. New components are reviewed against their own drawings and agreed specifications — published values are project-specific requirements, not general capability limits.

Related

START WITH YOUR DRAWING

Have a similar project?

Chat on WhatsApp