NEXUS Send drawings
INDUSTRY / AUTOMOTIVE & POWERTRAIN

Automotive & powertrain components.

Powertrain parts are route-heavy: heat treatment, datum correction, finish grinding and balancing are planned from the start. The published cases here carry the numbers — a 20CrMnTi camshaft and a 42CrMoV face gear with the full route as agreed.

MACHINING SCOPE
01

Camshafts & stepped shafts

Multi-diameter journals, eccentric cam sections, threaded ends — carbonitrided and ground.
02

Transmission & positioning gears

Face gears with radial teeth — indexing, concentricity and runout controlled.
03

Flanges, covers & brackets

Engine and transmission interfaces where flatness and hole position matter.
04

Secondary process coordination

Heat treatment, grinding and balancing sequenced with machining from the first review.
TYPICAL APPLICATIONS

Part families, materials, verification.

Typical part familyTypical materialsVerification focus
Camshafts & stepped shafts20CrMnTi-type alloy steelCam phase & journal alignment post-HT, Ra ≤ 0.4 µm (published case)
Face gears & transmission parts42CrMoV-type alloy steelTooth profile & indexing, runout, contact pattern (published case)
Flanges & coversAluminium alloys, steelsMating-face flatness, hole-array position
Small-batch engine componentsPer drawingFirst-article reports, magnetic particle testing, dynamic balance

See the cases

Precision stepped shaft — 20CrMnTi camshaft, Ø35 × 260 mm · Precision face gear — 42CrMoV, Ø80 × 65 mm.

COMMON QUESTIONS

A clear start.

Do you hold IATF 16949 certification?
Not published. Powertrain work runs on the ISO 9001 certified quality system with drawing-based inspection, material traceability from named producers, and documentation agreed per project — state the requirement and we confirm scope at review.
What does the camshaft case show?
A 20CrMnTi stepped camshaft with an eccentric cam section for engine valve timing — carbonitrided, center-hole corrected, finish ground, Ra ≤ 0.4 µm on critical journals, with magnetic particle testing and dynamic balance in the inspection scope.
What does the gear case show?
A 42CrMoV face gear for a precision transmission/positioning assembly — carbonitrided and form ground, tooth-surface finish Ra ≤ 0.4 µm, with mating contact pattern verification.
What batch sizes do you run?
Prototype, pilot and repeat production runs. Route, inspection level and delivery expectations are agreed during the drawing review.
START WITH YOUR DRAWING

Start with your drawing.

Chat on WhatsApp